| how to use & indications |
TECHNIQUE
  • Leave prep slightly moist
  • No bonding agent required, or other prep treatment
  • Clean crown after try-in, 1 quick air-blast to dry
  • DO NOT use silane, primers, or other treatments on crown surface
  • NOTE: etch lithium disilicate with 5% hydrofluoric acid for 20 seconds
  • Mix cement and load crown with Ceramir C&B
  • 2 minutes working time after mixing
  • Clean-up at gel phase at 3 minutes
  • Fully set at 5 minutes
INDICATIONS FOR USE
  • PFM
  • Lithium disilicate
  • Zirconia
  • Alumina
  • Implant crowns
  • Pedo stainless steel, layered, and all-zirconia crowns
  • Cast and pre-fab metal posts
  • Gold inlays/onlays
How to use Ceramir Crown & Bridge QuikCap: A Step-by-Step Video